| Assembly Instructions | cold press head can be used or not used when connecting wires |
| Product Type | Circular connector (cable side) |
| Application | power supply |
| Sensor Type | power supply |
| Bits | 4 |
| Outlet No. | 1 |
| Shielding | None |
| coding | T |
| cable outlet | straight head |
| Pg screw connection | Pg11 |
| insulation characteristics | |
| Overvoltage Category | III |
| pollution level | 3 |
| Dimensional drawing |  |
| width | 20mm |
| height | 20mm |
| length | 65.5mm |
| joint nut wrench specifications | 19mm |
| External dimensions | |
| outside diameter | 8mm ... 10mm |
| shell | |
| diameter shell | 20mm |
| flame retardant rating to UL 94 | V0 |
| sealing material | NBR |
| Fixture body material | PA |
| Contact Material | CuZn |
| Material Contact Surface | Au |
| Contact Carrier Material | PA |
| screw connection material | zinc cast, nickel plated |
| Wire Connection | |
| Connection Mode | screw connection |
| Wiring cross section | 0.75 mm² ... 1.5 mm² (without cold head) |
| 0.75 mm² ... 1.5 mm² (with cold press head) | |
| 0.75 mm² ... 2.5 mm² (rigid) | |
| Connectable Wire Cross Section AWG | 18 ... 14 (without cold press head) |
| 18 ... 16 (with cold pressing head) | |
| the stripping length of a single wire | 5mm |
| Tightening torque | 0.4 Nm (M12 coil) |
| 1.5 Nm ... 2 Nm (compression screw and plug housing) | |
| 0.4 Nm (plug screwed into plug housing as far as possible) | |
| 0.2 Nm (screw terminal block) | |
| Rated overvoltage | 1.5 kV |
| contact resistance | ≤ 3 mΩ |
| insulation resistance | > 10 GΩ |
| Rated voltage UN | 63V DC |
| Rated current IN | 12 A (when 1.5 mm² stranded wire is used) |
| 12 A (at 40°C) |
| Mechanical parameters | |
| Insertion/unplugging cycle | ≥ 100 |
Phoenix SACC-M12MST-3PECON-PG11-M-power connector 1404643
Created on：2025-02-11 15:36
