Phoenix PLC-OSC- 24DC/ 24DC/ 10/R-solid state relay module 2982702,PLC-INTERFACE with confirmation contacts, including base terminals, using screw connection and integrated miniature solid state relay, for installation on DIN rail NS 35/7,5, 1 normally open contact, input: 24V DC, output: 3V DC ... 33V DC/10 A
Product Type
Solid State Relay Module
product series
PLC-INTERFACE
Application
with built-in solid state relay
Mode of operation
100% operating factor
insulation characteristics: electrical clearance and creepage distance between power supply circuits
insulation
Foundation Isolation
Overvoltage Category
II
pollution level
2
Data Management Status
Last data maintenance date
13.11.2024
rated conditions
0.07W
Electrical clearance and creepage distance between power supply circuits
Rated insulation voltage
50V DC
Rated overvoltage
0.5 kV
Rated operating voltage UC
24V DC
Rated operating current IC
3.5 mA
switch threshold "0" signal, reference UN
< 0.4
switch threshold "1" signal, reference UN
> 0.8
Typical Response Time
100 µs
Typical closing time
500 µs
Operating voltage display
yellow LED
protection circuit
polarity protection; polarity protection diode
surge protection
overvoltage protection
> 33V
sending frequency
100Hz
Name
DC voltage output
Contact Type
1 N/O contact
Digital Output Design
electronic
Contact Type
power supply pin position
Output Voltage Range
8V DC ... 33V DC
limit continuous current
10 A (see temperature load curve)
quiescent current
5.2 mA
Voltage drop at maximum limited continuous current
< 50 mV
output circuit
3-wire connection, reference ground
protection circuit
reverse diode
surge protection
Name
Alarm output
Output Voltage Range
3V DC ... 33V DC
limit continuous current
100 mA
overvoltage protection
> 33V
Voltage drop at maximum limited continuous current
< 1.2V
output circuit
2-wire connection, floating
error indication
Red LED
protection circuit
polarity protection; polarity protection diode
Surge protection; Suppressor diode
Connection Mode
screw connection
stripping length
8mm
thread
M3
Rigid conductor cross section
0.14 mm² ... 2.5 mm²
Flexible Wire Cross Section
0.14 mm² ... 2.5 mm²
0.2 mm² ... 2.5 mm² (single sleeve)
2x 0.5 mm² ... 1.5 mm² (TWIN sleeve)
Connectable Guide Cross Section AWG
26 ... 14
Tightening torque
0.45 Nm ... 0.55 Nm (Normally, these terminal bases must be supported (held with one hand and supported on the housing) when making wire connections)
Phoenix PLC-OSC- 24DC/ 24DC/ 10/R-Solid State Relay Module 2982702
