Phoenix UNO-PS/1AC/15DC/55W-power supply 2903001, UNO POWER power supply for DIN rail installation, primary switching mode, input: 1 phase, output: 15V DC/55W

AC operation
Rated input voltage range 100V AC ... 240V AC
Input Voltage Range 85V AC ... 264V AC
AC input voltage range 85V AC ... 264V AC
Supply Voltage AC
Impulse current < 25 A (typical)
impulse current integral (I2t) < 0.5 A2s (typical)
frequency range (fN) 50Hz ... 60Hz ± 10%
grid buffer time > 25 ms (120V AC)
> 90 ms (230V AC)
power consumption Typical 1.3 A (100V AC)
Typical 0.6 A (240V AC)
Rated power consumption 127.6 VA
protection circuit transient surge protection; varistor
power factor (cos phi) 0.49
Typical Response Time < 1 s
input fuse 3.15 A (slow fuse, internal)
recommend use 6 A ... 16 A (characteristics B, C, D, K)

efficiency 87% typical (120V AC)
Typical 88% (230V AC)
output characteristics HICCUP
Rated output voltage 15V DC
Rated output current (IN) 3.7 A (-25°C ... 55 °C)
Attenuation 55°C ... 70°C (2.5 %/K)
feedback voltage resistance < 25V DC
output ≤ 25V DC
control deviation <1% (load change, static 10%... 90%)
<3% (dynamic load change 10%... 90%, 10Hz)
< 0.1 % (input voltage variation is ± 10 %)
residual wave < 50 mVSS(rated value)
Short-circuit protection is
output power 55W
maximum no-load power consumption < 0.3W
Maximum rated load power loss < 7W
rise time < 0.5 s (UOUT(10%... 90%))
response time < 2 ms
and connect Yes, for redundancy and increased capacity
Concatenation is

Input
Connection Mode screw connection
Minimum cross section of rigid conductor 0.2 mm²
Maximum cross section of rigid conductor 2.5 mm²
Minimum cross section of flexible lead 0.2 mm²
flexible conductor 2.5 mm²
Single conductor/flexible connection point, cold press head with plastic sleeve, minimum 0.2 mm²
Single wire/flexible connection point, cold press head with plastic sleeve, maximum 2.5 mm²
single-conductor/flexible connection point, cold press head without plastic sleeve, minimum 0.2 mm²
Single wire/flexible connection point, cold press head with plastic sleeve, maximum 2.5 mm²
Minimum Wire Cross Section AWG 24
Maximum conductor cross section AWG 14
stripping length 8mm
thread M3
Minimum tightening torque 0.5 Nm
Maximum tightening torque 0.6 Nm

Phoenix UNO-PS/1AC/15DC/ 55W-Power 2903001

Created on:2025-02-24 15:57

News Dynamics

NEWS