Phoenix SUBCON-PLUS M1-D-SUB bus connector 2761826,D-SUB connector, 9-bit, pin connector, two incoming lines <35, bus system: Modbus, Modbus Plus, BITBUS, ARCNET, MULT/MININET(B & R), SYSTEM 2003(B & R), P-NET, pin assignment: 1,2,3,5,6, 400.00g screw terminals
| Product Type |
Data plug |
| MTTF |
6706 years (SN 29500 standard, temperature 25°C, duty cycle 21%) |
| 1817 years (SN 29500 standard, temperature 40°C, duty cycle 34.25%) |
| 155 years (SN 29500 standard, temperature 40°C, duty cycle 100%) |
| Pin Distribution |
two terminals 1, 2, 3, 5, 6, 8 |
| Rated voltage UN |
50V DC |
| Rated current IN |
100 mA |
| transmission medium |
copper cable |
| D-SUB connection |
| Connection Mode |
D-SUB connector |
| PCB Connection |
| Connection Mode |
screw connection |
| stripping length |
5mm |
| Minimum cross section of rigid conductor |
0.14 mm² |
| Maximum cross section of rigid conductor |
1.5 mm² |
| flexible lead |
0.14 mm² |
| flexible conductor |
1 mm² |
| Single Wire/End Point, Minimum Rigid AWG |
26 |
| single wire/wiring point, maximum rigid AWG |
16 |
| AWG Wire Minimum Cross Section, Flexible |
26 |
| AWG stranded wire, flexible |
18 |
| bus system |
Modbus,BODBUS-PLUS,BITBUS,ARCNET,MULT/MININET( B &R),SYSTEM 2003( B &R),P-NET |
| signal |
RS-485 |
| Dimensional drawing |
|
| width |
16mm |
| height |
44mm |
| Length |
60mm |
| Identification Material (Shell) |
ABS (metal plating) |
| Cable outer diameter |
6mm ... 10 mm (bus line incoming) |
| Mechanical parameters |
| Insertion/unplugging cycle |
> 200 |
| meets EN 60068-2-6/IEC 60068-2-6 anti-vibration standards |
vibration (running): 5g,10 ... 150Hz, 2.5 h, XYZ direction |
| Conforms to EN 60068-2-27/IEC 60068-2-27 impact resistance standards |
impact force (operation): 15g,11 ms, half-sine shock pulse |
| environmental conditions |
| protection level |
IP20 |
| ambient temperature (operation) |
-20°C ... 75°C |
| ambient temperature (storage/transport) |
-25°C ... 80°C |
| elevation |
≤ 5000 m (see manufacturer's statement for high altitude operation for limits) |
| Allowable humidity (operating) |
10%... 95% (no condensation) |
| Permissible humidity (storage/transportation) |
5%... 95% (non-condensing) |
