Phoenix RIF-1-RPT-LDP-24DC/2X21MS-Relay Module 2905291, pre-assembled relay module with plug-in connection, including: relay base, relay bracket, high-power contact relay (with test button, integrated status LED and freewheeling diode). Contact type: 2 PDT. Input voltage: 24V DC
| Product Type |
Relay Module |
| product series |
RIFLINE complete |
| Application |
General |
| Handheld Switch |
| Mode of operation |
100% operating factor |
| mechanical life |
about 5 x 106times |
| insulation characteristics |
| insulation |
input and output |
| changeover contacts |
| Overvoltage Category |
III |
| pollution level |
2 |
| Data Management Status |
| Last data maintenance date |
20.03.2025 |
| service life, electrical |
See Graph |
| rated conditions |
0.43W |
| test voltage (coil/contact) |
4 kVrms(50Hz,1 min, coil/contact) |
| test voltage (changeover contact/changeover contact) |
2.5 kVrms(50Hz,1 minute, changeover contact/changeover contact) |
| Rated insulation voltage |
250V AC |
| Rated overvoltage |
6 kV (input/output) |
| 4 kV (between changeover contacts) |
| coil side |
| Rated input voltage UN |
24V DC |
| Input Voltage Range |
19.2V DC ... 30V DC (20 °C) |
| to UNas reference |
See Graph |
| mains frequency |
50/60Hz |
| drives and functions |
monostable |
| drive (polarity) |
polarization |
| UN |
18 mA |
| Typical Response Time |
9 ms |
| Typical release time |
10 ms |
| coil voltage |
24V DC |
| protection circuit |
freewheeling diode |
| Operating voltage display |
yellow LED |
| switching |
| Contact Type |
2 changeover contacts |
| Switch Contact Type |
single contact |
| Contact Material |
AgNi |
| maximum switching voltage |
250V AC/DC |
| Minimum Switching Voltage |
12V (10 mA) |
| limit continuous current |
8 A (see graph) |
| Maximum impact current |
12 A (20 ms, normally open contact) |
| minimum switching current |
10 mA (12 V) |
| Maximum power rating (resistive load) |
192W (24V DC) |
| 62W (available for 48V DC) |
| 42W (available for 60V DC) |
| 55W (available for 110V DC) |
| 66W (available for 220V DC) |
| 2000 VA (available for 250V AC) |
| Minimum on-off capacity |
120 mW |
| Use Class CB Scheme (IEC 60947-5-1) |
AC15, 1.5 A/250V (N/O contact) |
| DC13, 1 A/24V (N/O contact) |
| Connection Mode |
in-line connection |
| stripping length |
8mm |
| Rigid conductor cross section |
0.14 mm² ... 1.5 mm² |
| Flexible Wire Cross Section |
0.14 mm² ... 1.5 mm² |
| 0.14 mm² ... 1.5 mm² (cold press head with plastic sleeve) |
| 0.14 mm² ... 1 mm² (sleeve with plastic insulating sleeve, two wires on the two-position terminal) |
| Attachable Guide Cross Section AWG |
26 ... 16 (rigid) |
| 26 ... 16 (flexible) |
