Phoenix IB IL AO 2/U/BP-PAC-analog module 2861467,Inline, analog output module, analog output: 2,0V ... 10V,-10V ... 10V, connection technology: 2-wire system, local bus transmission rate: 500 kBit/s, protection level: IP20, including Inline connector and identification area
| width | 12.2mm |
| height | 136.8mm |
| depth | 71.5mm |
| Application Description | |
| Application Description | for industrial applications only |
| Use Restrictions | |
| CCCex Description | is not permitted in China for use in potentially explosive areas. |
| Inline Local Bus | |
| interfaces | 2 |
| Connection Mode | Inline Data Bridge Block |
| transmission speed | 500 kBit/s |
| transmission principle | copper cable |
| Module | |
| ID Code (dec.) | 91 |
| Hex ID Encoding | 5B |
| Length Encoding (Hexadecimal) | 02 |
| length encoding (decimal) | 02 |
| Process Data Channel | 32 bits |
| Input Address Area | 4 Byte |
| Output Address Area | 4 Byte |
| Register Length | 32 bits |
| the required parameter data | 6 Byte |
| 5 Byte | |
| simulation: | |
| Output Name | analog output |
| Output Description | single-ended |
| connection system | 2 wire system |
| Notes on connection technology | Shielding |
| outputs | 2 |
| D/A conversion time | < 100 ns |
| protection circuit | output |
| data format | IB IL,IB ST |
| an expression for the output value | 16-bit (15-bit sign) |
| DAC resolution | 13. |
| Process Data Update | < 1 ms |
| voltage output signal | 0V ... 10V |
| -10V ... 10V | |
| load/output load voltage output | > 2 kΩ |
| Allowable Cable Length | Maximum 500 m (this specification is carried out in accordance with the installation requirements and conforms to the standard operation. The specifications apply to the following reference cable models: Shielded power cable: LiYCY;2 x 2 x 0,5 mm²;VDE0812) |
| Product Type | I/O components |
| product series | Inline |
| type | Module |
| Scope of supply | includes Inline connector and identification area |
| diagnostic information | failure or communication power ULUnderpower I/O error message sent to bus coupler |
| insulation characteristics | |
| Overvoltage Category | II (IEC 60664-1,EN 60664-1) |
| pollution level | 2 (IEC 60664-1,EN 60664-1) |
| rated conditions | 1.15W |
| potential: communication power supply (UL) | |
| supply voltage | 7.5V DC (across the power supply) |
| current consumption | max. 40 mA |
| Typical 33 mA | |
| potential: power supply of analog module (UANA) | |
| supply voltage | 24V DC (via power crossover) |
| Supply Voltage Range | 19.2V DC ... 30V DC (includes all tolerances, including ripple) |
| current consumption | maximum 35 mA (full load (RL= 2 kΩ)) |
| Maximum 28 mA (no load) | |
| typical 25 mA (full load (RL= 2 kΩ)) | |
| Typical 18 mA (no load) | |
Phoenix IB IL AO 2/U/BP-PAC-Analog Module 2861467
