ꄴPrevious： Phoenix PLC-RPT- 24DC/21AU-Relay module 2900306
ꄲNext： Phoenix REL-IR4/L-230AC/4X21-Single Relay 2903688

Phoenix REL-IR4/L-120AC/4X21-single relay 2903687, plug-in industrial relay, with power contacts, 4 PDT, test button, status LED, mechanical switch position display, coil voltage: 120V AC

Product Type Single relay
Mode of operation 100% operating factor
mechanical life approx. 2x 107times
insulation characteristics
insulation Foundation Isolation
Overvoltage Category II
pollution level 2
Data Management Status
Last data maintenance date 17.01.2025

service life, electrical See Graph
rated conditions 1.56W
test voltage (coil/contact) 2.5 kVrms(50Hz,1 min, coil/contact)
test voltage (changeover contact/changeover contact) 2 kVrms(50Hz,1 minute, changeover contact/changeover contact)
Rated insulation voltage 250V AC
Rated overvoltage 2.5 kV

coil side
Rated input voltage UN 120V AC
Input Voltage Range 93.6V AC ... 165.6V AC (20 °C)
mains frequency 50/60Hz
drives and functions monostable
drive (polarity) Inpolarity
UN 13 mA
Typical Response Time 5 ms ... 15 ms (depending on phase)
Typical Release Time Range 5 ms ... 20 ms (depending on phase)
Status Display LED (yellow)

switching
Contact Type 4 PDT
Switch Contact Type Single contact
Contact Material AgNi
maximum switching voltage 250V AC/DC
Minimum Switching Voltage 5V (when 24 mA)
limit continuous current 6 A
Maximum starting current 16 A (20 ms, normally open contact)
minimum switching current 5 mA (24 V)
Maximum power rating (resistive load) 144W (24V DC)
124W (available for 48V DC)
108W (available for 60V DC)
52W (available for 110V DC)
48W (available for 220V DC)
1500 VA (available for 250V AC)
Minimum on-off capacity 0.12W
switch capacity 2 A (24V, DC13)
0.22 A (120V, DC13)
0.11 A (250V, DC13)
1.5 A (24V, AC15)
1.5 A (120V, AC15)
1 A (240V, AC15)
UL 508 Motor Loads 1/3 HP,240 V AC

Connection Mode in-line connection

width 21.2mm
height 27.5mm
depth 35.6mm
2903666
넳 넲

Phoenix REL-IR4/L-120AC/4X21-Single Relay 2903687

Product Center

PRODUCT CENTER

▼