Phoenix MACX MCR-SL-2I-2I-ILP-SP-passive isolator 2905281, dual-channel input loop-powered 2-way isolator, using in-line connection technology, used for galvanic isolation of analog signals. Input signal = output signal: 0(4) mA ... 20 mA. In-line connection technology.
| Product Type | isolation amplifier |
| product series | MACX Analog |
| Channels | 2 |
| Model | Isolation Amplifier with SIL Functional Safety |
| electrical isolation | 2 road isolation |
| Signal Transmission Behavior | In = Out |
| maximum temperature coefficient | ≤ 0.002 %/K (measured value/100 Ω load) |
| Typical transmission error | 0.08 % (of terminal value) |
| electrical isolation | |
| Test Voltage | 2.5 kV AC (50 Hz, 60 s) |
| Overvoltage Category | II |
| pollution level | 2 |
| Electrically isolated input/output/power supply IEC/EN 61010-1 | |
| Standards/Regulations | IEC/EN 61010-1 |
| Rated insulation voltage | 300Vrms |
| insulation | security isolation |
| power supply | |
| Supply Voltage Range | loop power supply, no external power supply required |
| signals: current | |
| Input Number | 2 |
| configurable/programmable | No |
| Maximum voltage input signal | < 30.5V |
| current input signal | 0 mA ... 20 mA |
| 4 mA ... 20 mA | |
| Input Voltage Limit | 30.5V |
| voltage loss | 2.9V (I = 20 mA) |
| step response (10-90%) | 5 ms (500 Ω load) |
| additional error, depending on the load | 0.022 % (measured value/100 Ω load) |
| response current | ~ 50 µA |
| signals: current | |
| outputs | 2 |
| configurable/programmable | No |
| Maximum voltage output signal | 27.5V |
| current output signal | 0 mA ... 20 mA |
| 4 mA ... 20 mA | |
| load/output load current output | ≤ 1375 Ω (I = 20 mA) |
| residual wave | < 10 mVrms(500 Ω load) |
| Connection Mode | in-line connection |
| stripping length | 10mm |
| Rigid conductor cross section | 0.2 mm² ... 2.5 mm² |
| Flexible Wire Cross Section | 0.2 mm² ... 2.5 mm² |
| flexible wire cross section (2 wires with the same cross section) | 0.25 mm² ... 0.34 mm² (TWIN cold press head without plastic sleeve) |
| 0.5 mm² ... 1.5 mm² (TWIN sleeve with plastic insulating sleeve) |
Phoenix MACX MCR-SL-2I-2I-ILP-SP-Passive Isolator 2905281
