Phoenix PLC-RPT- 24DC/ 1ICT/ACT-relay module 1078683,PLC-INTERFACE suitable for high inrush current, including PLC-BPT.../1 IC/ACT base terminal, using plug-in interface and pluggable micro relay, can be installed on DIN rail NS 35/7,5, the maximum inrush current is up to 800 A,1 normally open contact, input voltage 24V DC
Product Type
Relay Module
Product Series
PLC-INTERFACE
Application
Large impact current
Mode of operation
100% operating factor
mechanical life
3x 107Switch Times
insulation characteristics: standards/regulations
insulation
safety isolation, reinforced insulation
Overvoltage Category
III
pollution level
3
Data Management Status
Last data maintenance date
21.03.2025
rated conditions
0.43W
test voltage (coil/contact)
4 kV AC (50Hz,1 min, coil/contact)
Standards/Regulations
Rated insulation voltage
250V AC
Rated overvoltage
6 kV
coil side
Rated input voltage UN
24V DC
Input Voltage Range
20.2V DC ... 33.6V DC (20 °C)
rated voltage ("hot" plug electromagnetic relay)
24V DC
drives and functions
monostable
drive (polarity)
polarization
UN
18 mA
Typical Response Time
8 ms
Typical release time
10 ms
protection circuit
polarity protection; polarity protection diode
surge protection; freewheeling diode
Operating voltage display
yellow LED
switching
Contact Type
1 N/O contact
Switch Contact Type
single contact
Remarks on switch contacts
with tungsten lead contacts
Contact Material
AgSnO
Considerations
main contact, silver tin oxide (AgSnO2): lead contact, tungsten
maximum switching voltage
250V AC/DC
Minimum Switching Voltage
12V (100 mA)
limit continuous current
6 A
10 A (applicable if terminals 13, 14 and BB are shorted)
Maximum impact current
165 A (20 ms)
800 A (200 µs)
minimum switching current
100 mA (12 V)
Maximum power rating (resistive load)
144W (24V DC, pay attention to contact de-capacitance)
