Phoenix PLC-RPT- 5DC/1/SSI-Relay module 1094764,PLC-INTERFACE, including plug-in connection base terminals and "hot" plug-in micro-relays, internal amplifier circuit and a suitable auxiliary power supply for weak signal sources, 1 normally open contact, 5V DC rated input voltage
| Product Type | Relay Module |
| product series | PLC-INTERFACE |
| Application | weak signal source |
| Mode of operation | 100% operating factor |
| mechanical life | 2x 107Switch Times |
| Data Management Status | |
| Last data maintenance date | 21.03.2025 |
| rated conditions | 0.22W |
| insulation characteristics: coil/contact | |
| Rated insulation voltage | 250V |
| Rated impulse withstand voltage | 6 kV |
| Overvoltage Level | III |
| pollution level | 3 |
| power supply | |
| Rated supply voltage | 24V DC (Us) |
| US | 0.8 ... 1.2 |
| input current | 9 mA |
| coil side | |
| Rated input voltage UN | 5V DC |
| Input Voltage Range | 4.5V DC ... 6V DC |
| rated voltage ("hot" plug electromagnetic relay) | 24V DC |
| drives and functions | monostable |
| drive (polarity) | polarization |
| UN | 1 mA |
| Typical Response Time | 5 ms |
| Typical release time | 7 ms |
| protection circuit | Surge Protection |
| Operating voltage display | yellow LED |
| switching | |
| Contact Type | 1 N/O contact |
| Switch Contact Type | single contact |
| Contact Type | power supply pin position |
| Contact Material | AgSnO |
| maximum switching voltage | 250V AC/DC |
| Minimum Switching Voltage | 12V AC/DC |
| limit continuous current | 6 A |
| Maximum impact current | 10 A (4 s) |
| minimum switching current | 10 mA |
| short-circuit current | 200 A (condition short-circuit current) |
| Maximum power rating (resistive load) | 140W (24V DC) |
| 20W (available for 48V DC) | |
| 18W (available for 60V DC) | |
| 23W (available for 110V DC) | |
| 40W (available for 220V DC) | |
| 1500 VA (available for 250V AC) | |
| Minimum on-off capacity | 120 mW |
| output fuse | 4 A gL/gG NEOZED |
Phoenix PLC-RPT- 5DC/1/SSI-Relay Module 1094764
