Phoenix PLC-RPT-230UC/21-21AU/RWF-Relay module 2900345, suitable for PLC-INTERFACE in rail transit applications, including base terminals, using plug-in connection and with plug-in miniature multi-layer gold-plated contact relay, range: 0.75 x UN to 1.15 x UN, rated input frequency 16.7Hz,2 PDT, input voltage 230V AC
Product Type
Relay Module
Product Series
PLC-INTERFACE
Application
Railway applications
Mode of operation
100% operating factor
mechanical life
approx. 3x 107times
insulation characteristics: electrical clearance and creepage distance between power supply circuits
insulation
Foundation Isolation
Overvoltage Category
III
pollution level
2
Data Management Status
Last data maintenance date
21.03.2025
rated conditions
1.1W
test voltage (coil/contact)
6 kV (50Hz,1 min, coil/contact)
Electrical clearance and creepage distance between power supply circuits
Rated insulation voltage
250V AC
Rated overvoltage
6 kV
coil side
Rated input voltage UN
230V AC
Input Voltage Range
172.5V AC ... 264.5V AC (20 °C)
rated voltage ("hot" plug electromagnetic relay)
110V DC
mains frequency
16.67Hz
drives and functions
monostable
drive (polarity)
polarization
UN
4.8 mA (AC)
Typical Response Time
20 ms
Typical release time
60 ms
protection circuit
Bridge Rectifier
Operating voltage display
yellow LED
switching
Contact Type
2 changeover contacts
Switch Contact Type
single contact
Contact Material
AgNi, hard gold plating
Considerations
if the maximum upper limit value is exceeded, the gold plating layer is destroyed. At this time, the threshold of AgNi contact material is in effect, but the service life may be shortened.
maximum switching voltage
30V AC
36V DC
Minimum Switching Voltage
100 mV
limit continuous current
50 mA
Maximum impact current
50 mA
minimum switching current
1 mA
Maximum power rating (resistive load)
1.2W (24V DC)
switch capacity
2 A (24V(DC13) to DIN VDE 0660/IEC 60947)
0.2 A (220V DC / 230V AC(DC13) according to DIN VDE 0660/IEC 60947)
3 A (220V DC / 230V AC(AC15) according to DIN EVDE 0660/IEC 60947)
switching: when the gold plating layer is destroyed
Considerations
If the gold plating is damaged, the following values are applicable.
Contact Material
AgNi
maximum switching voltage
250V AC/DC (When the voltage between the same terminal blocks of two adjacent modules is greater than 250V(L1, L2, L3), the partition PLC-ATP must be used.)
