Phoenix PLC-RSC- 24DC/PMC T200/21HC-Timer Relay 2307293, Combined Timing Relay, Pre-moving Contact with Plug-in Micro Relay and Screw Connection
| Product Type | Relay Module |
| product series | PLC-INTERFACE |
| Mode of operation | 100% operating factor |
| mechanical life | about 2x 107times |
| insulation characteristics: electrical clearance and creepage distance | |
| insulation | Safety isolation, enhanced isolation (insulation board PLC-ATP should be installed between adjacent modules to ensure safety). |
| Overvoltage Category | III |
| pollution level | 3 |
| Data Management Status | |
| Last data maintenance date | 19.03.2025 |
| rated conditions | 0.4W |
| coil side | |
| Rated input voltage UN | 24V DC |
| Input Voltage Range | 19.2V DC ... 26.4V DC (20 °C) |
| rated voltage ("hot" plug electromagnetic relay) | 24V DC |
| UN | 15 mA (relay ON) |
| 4.3 mA (relay OFF) | |
| Typical Response Time | 7 ms |
| Typical release time | 200 ms +130 ms (UN) |
| protection circuit | surge protection; freewheeling diode |
| Operating voltage display | yellow LED |
| switching | |
| Contact Type | Single contact, 1 changeover contact |
| Switch Contact Type | single contact |
| Contact Material | AgNi, hard gold plating |
| maximum switching voltage | 250V AC/DC (When the voltage between the same terminal blocks of two adjacent modules is greater than 250V(L1, L2, L3), the partition PLC-ATP must be used.) |
| Minimum Switching Voltage | 12V AC/DC |
| limit continuous current | 10 A |
| Maximum starting current | 16 A |
| minimum switching current | 100 mA |
| switching: when the gold plating layer is destroyed | |
| Maximum power rating (resistive load) | 240W (24V DC) |
| 144W (available for 48V DC) | |
| 48W (available for 60V DC) | |
| 50W (available for 110V DC) | |
| 80W (available for 220V DC) | |
| 4000W (available for 250V AC) | |
| Connection Mode | screw connection |
| stripping length | 8mm |
| thread | M3 |
| Rigid conductor cross section | 0.14 mm² ... 2.5 mm² |
| Flexible Wire Cross Section | 0.14 mm² ... 2.5 mm² |
| 0.2 mm² ... 2.5 mm² (single sleeve) | |
| 2x 0.5 mm² ... 1.5 mm² (TWIN sleeve) |