Phoenix PLC-RSC- 24UC/21-21AU/MS-Relay module 2910508,PLC-INTERFACE, including relay base and pluggable multi-layer gold contact relay (with manual operation and integrated status LED), screw connection, 2 Switching contacts, bridge rectifier, input voltage: 24V AC/DC
| Product Type |
Relay Module |
| product series |
PLC-INTERFACE |
| Application |
Handheld Switch |
| Mode of operation |
100% operating factor |
| mechanical life |
5x106Switch Times |
| insulation characteristics: electrical clearance and creepage distance between power supply circuits |
| insulation |
safety isolation, reinforced insulation |
| Overvoltage Category |
III |
| pollution level |
2 |
| Data Management Status |
| Last data maintenance date |
20.03.2025 |
| rated conditions |
0.44W |
| test voltage (coil/contact) |
4 kVrms(50 Hz,1 min) |
| test voltage (changeover contact/changeover contact) |
2.5 kVrms(50 Hz,1 min) |
| Electrical clearance and creepage distance between power supply circuits |
| Rated insulation voltage |
250V AC |
| Rated overvoltage |
6 kV |
| coil side |
| Rated input voltage UN |
24V AC/DC |
| Input Voltage Range |
20.6V AC/DC ... 33.6V AC/DC (20 °C) |
| rated voltage ("hot" plug electromagnetic relay) |
24V DC |
| drives and functions |
monostable |
| drive (polarity) |
polarization |
| UN |
18 mA |
| Typical Response Time |
3 ms ... 15 ms |
| Typical Release Time Range |
3 ms ... 15 ms |
| protection circuit |
bridge rectifier |
| Operating voltage display |
yellow LED |
| switching |
| Contact Type |
2 changeover contacts |
| Switch Contact Type |
single contact |
| Contact Material |
AgNi, hard gold plating |
| maximum switching voltage |
30V AC |
| 36V DC |
| Minimum Switching Voltage |
12V (1 mA) |
| limit continuous current |
50 mA |
| Maximum impact current |
50 mA |
| minimum switching current |
1 mA (12 V) |
| switching: when the gold plating layer is destroyed |
| Considerations |
If the gold plating is damaged, the following values are applicable. |
| maximum switching voltage |
250V AC/DC |
| Minimum Switching Voltage |
12V |
| limit continuous current |
6 A |
| Maximum impact current |
12 A (20 ms) |
