Phoenix PLC-RSC- 48DC/21-21/MS-Relay module 2910504,PLC-INTERFACE, including relay base and pluggable power contact relay (with manual operation, integrated status LED and freewheeling diode), screw connection, 2 Switching contacts, bridge rectifier, input voltage: 48V DC

Product Type Relay Module
product series PLC-INTERFACE
Application Handheld Switch
Mode of operation 100% operating factor
mechanical life 5x106Switch Times
Insulation Characteristics: Standards/Regulations
insulation safety isolation, reinforced insulation
Overvoltage Category III
pollution level 2
Data Management Status
Last data maintenance date 20.03.2025

rated conditions 0.92W
test voltage (coil/contact) 4 kVrms(50Hz,1 min, coil/contact)
test voltage (changeover contact/changeover contact) 2.5 kVrms(50Hz,1 minute, changeover contact/changeover contact)
Standards/Regulations
Rated insulation voltage 250V AC
Rated overvoltage 6 kV

coil side
Rated input voltage UN 48V DC
Input Voltage Range 40.3V DC ... 62.4V DC (20 °C)
rated voltage ("hot" plug electromagnetic relay) 24V DC
drives and functions monostable
drive (polarity) polarization
UN 19 mA
Typical Response Time 6 ms
Typical release time 10 ms
protection circuit Bridge Rectifier
Operating voltage display is

switching
Contact Type 2 changeover contacts
Switch Contact Type Single contact
Contact Material AgNi
maximum switching voltage 250V AC/DC (When the voltage between the same terminals of two adjacent modules is greater than 250V(L1, L2, L3), a spacer PLC-ATP must be used. FBST 8-PLC... or... FBST 500... for equipotential bridging)
Minimum Switching Voltage 12V (10 mA)
limit continuous current 6 A
Maximum impact current 12 A (20 ms)
minimum switching current 10 mA (12 V)
Maximum power rating (resistive load) 192W (24V DC)
62W (48V DC)
42W (60V DC)
55W (110V DC)
66W (220V DC)
2000 VA (250V AC)
switch capacity 1 A (24V (DC13))
1.5 A (230 V, AC15)
2910519

Phoenix PLC-RSC- 48DC/21-21/MS-Relay Module 2910504

Product Center

PRODUCT CENTER