Phoenix PLC-RSC-120UC/21-21/MS-relay module 2910505,PLC-INTERFACE, including relay base and pluggable power contact relay (with manual operation and integrated status LED), screw connection, 2 conversion contacts, bridge Rectifier, input voltage: 120V AC / 110V DC

Product Type Relay Module
product series PLC-INTERFACE
Application Handheld Switch
Mode of operation 100% operating factor
mechanical life 5x106Switch Times
Insulation Characteristics: Standards/Regulations
insulation safety isolation, reinforced insulation
Overvoltage Category III
pollution level 2
Data Management Status
Last data maintenance date 20.03.2025

rated conditions 0.6W
test voltage (coil/contact) 4 kVrms(50Hz,1 min, coil/contact)
test voltage (changeover contact/changeover contact) 2.5 kVrms(50Hz,1 minute, changeover contact/changeover contact)
Standards/Regulations
Rated insulation voltage 250V AC
Rated overvoltage 6 kV

coil side
Rated input voltage UN 120V AC
110V DC
Input Voltage Range 96V AC ... 168V AC (20 °C)
93.5V DC ... 154V DC (20 °C)
rated voltage ("hot" plug electromagnetic relay) 110V DC
drives and functions monostable
drive (polarity) polarization
UN 5 mA
Typical Response Time 6 ms (110V DC)
3 ms ... 15 ms (120V AC)
Typical release time 10 ms (110V DC)
Typical Release Time Range 3 ms ... 15 ms (120V AC)
protection circuit bridge rectifier
Operating voltage display yellow LED

switching
Contact Type 2 changeover contacts
Switch Contact Type single contact
Contact Material AgNi
maximum switching voltage 250V AC/DC (When the voltage between the same terminals of two adjacent modules is greater than 250V(L1, L2, L3), a spacer PLC-ATP must be used. FBST 8-PLC... or... FBST 500... for equipotential bridging)
Minimum Switching Voltage 12V (10 mA)
limit continuous current 6 A
Maximum impact current 12 A (20 ms)
minimum switching current 10 mA (12 V)
Maximum power rating (resistive load) 192W (24V DC)
62W (48V DC)
42W (60V DC)
55W (110V DC)
2910519

PHENOX PLC-RSC-120UC/21-21/MS-RELAY MODULE 2910505

Product Center

PRODUCT CENTER