Phoenix PLC-RSC-120UC/21HC-relay module 2967662,PLC-INTERFACE, including PLC-BSC.../21 HC base terminal, using screw connection, with plug-in micro relay, suitable for high continuous current, for installation on DIN rail NS 35/7.5, limit continuous current up to 10 A,1 PDT, input voltage 120V AC/110V DC
Product Type
Relay Module
Product Series
PLC-INTERFACE
Application
Large impact current
Mode of operation
100% operating factor
mechanical life
3x 107Switch Times
insulation characteristics
insulation
safety isolation, reinforced insulation
Overvoltage Category
III
pollution level
3
Data Management Status
Last data maintenance date
19.03.2025
rated conditions
0.54W
test voltage (coil/contact)
4 kV AC (50Hz,1 min, coil/contact)
Rated overvoltage
6 kV
coil side
Rated input voltage UN
120V AC
110V DC
Input Voltage Range
102V AC ... 168V AC (20 °C)
85.8V DC ... 154V DC (20 °C)
rated voltage ("hot" plug electromagnetic relay)
110V DC
drives and functions
monostable
drive (polarity)
polarization
UN
4.2 mA (available for 110V DC)
4.5 mA (for 120V AC)
Typical Response Time
7 ms
Typical release time
10 ms
protection circuit
bridge rectifier
Operating voltage display
yellow LED
switching
Contact Type
1 changeover contact
Switch Contact Type
Single contact
Contact Material
AgNi
maximum switching voltage
250V AC/DC (When the voltage between the same terminals of two adjacent modules is greater than 250V(L1, L2, L3), a spacer PLC-ATP must be used. FBST 8-PLC... or... FBST 500... for equipotential bridging)
Minimum Switching Voltage
12V (10 mA)
limit continuous current
10 A
6 A (This value only applies to terminal 12. If terminal 12 is shorted, the rating of the relay is used.)
