Phoenix GW PL DP/HART-Transmission Protocol Converter 2316362,HART Protocol to PROFIBUS DP Protocol Converter
| Product Type | Interface Interface Converter |
| insulation characteristics | |
| Overvoltage Category | II |
| pollution level | 2 |
| power supply | |
| Supply Voltage Range | 18.5V DC ... 30V DC () |
| Rated supply voltage | 24V DC |
| Maximum current consumption | 75 mA |
| power supply | |
| Connection Mode | plug-in COMBICON screw terminal block |
| Flexible Wire Cross Section | 0.20 mm² ... 2.50 mm² |
| Hard Wire Cross Section | 0.20 mm² ... 2.50 mm² |
| Connectable Guide Cross Section AWG | 24 ... 12 |
| Tightening torque | 0.5 Nm ... 0.6 Nm |
| Data: PROFIBUS DP | |
| Data Rate | 9.6 kbps (minimum) |
| 12 Mbps (max.) | |
| connection quantity | 2 |
| Connection Mode | D-SUB-9, COMBICON |
| Channels | 1 |
| Tightening torque | 0.5 Nm ... 0.6 Nm |
| connection system | screw connection |
| terminal resistance | 390 Ω - 220 Ω - 390 Ω (switchable) |
| Flexible lead maximum cross section | 2.5 mm² |
| flexible lead | 0.2 mm² |
| Maximum cross section of rigid conductor | 2.5 mm² |
| Minimum cross section of rigid conductor | 0.2 mm² |
| Maximum conductor cross section AWG | 12 |
| Minimum Wire Cross Section AWG | 24 |
| Supported Protocols | HART,PROFIBUS DP |
| data: HART FSK | |
| connection quantity | 3 |
| Connection Mode | COMBICON |
| Channels | 4 (active/passive HART devices) |
| Tightening torque | 0.5 Nm ... 0.6 Nm |
| connection system | screw connection |
| Flexible lead maximum cross section | 2.5 mm² |
| flexible lead | 0.2 mm² |
| Maximum cross section of rigid conductor | 2.5 mm² |
| Minimum cross section of rigid conductor | 0.02 mm² |
| Maximum conductor cross section AWG | 12 |
| Minimum Wire Cross Section AWG | 24 |
Phoenix GW PL DP/HART-Transport Protocol Converter 2316362
