Phoenix RIF-1-RPT-LV-120AC/1X21MS-Relay Module 2909776, a prefabricated relay module with in-line connection, including: relay base, relay fixing bracket, plug-in display/interference suppression module, and power contact with test button and built-in status LED Relay. Contact switching type: 1 changeover contact. Input voltage: 120V AC
Product Type
Relay Module
product series
RIFLINE complete
Application
General
Handheld Switch
Mode of operation
100% operating factor
mechanical life
about 5 x 106times
insulation characteristics
insulation
input and output
changeover contacts
Overvoltage Category
III
pollution level
2
Data Management Status
Last data maintenance date
20.03.2025
service life, electrical
See Graph
rated conditions
0.84W
test voltage (coil/contact)
4 kVrms(50Hz,1 min, coil/contact)
Rated insulation voltage
250V AC
Rated overvoltage
6 kV (input/output)
4 kV (between changeover contacts)
coil side
Rated input voltage UN
120V AC
Input Voltage Range
96V AC ... 132V AC (20 °C)
to UNas reference
See Graph
mains frequency
50/60Hz
drives and functions
monostable
drive (polarity)
polarization
UN
7 mA
Typical Response Time
4 ms ... 10 ms
Typical Release Time Range
3 ms ... 20 ms
coil voltage
120V AC
protection circuit
varistor
Operating voltage display
yellow LED
switching
Contact Type
1 changeover contact
Switch Contact Type
single contact
Contact Material
AgNi
maximum switching voltage
250V AC/DC
Minimum Switching Voltage
12V (10 mA)
limit continuous current
8 A (see graph)
Maximum impact current
32 A (20 ms, normally open contact)
minimum switching current
10 mA (12 V)
Maximum power rating (resistive load)
264W (24V DC)
62W (48V DC)
48W (60V DC)
52W (110V DC)
66W (220V DC)
2500 VA (250V AC)
Minimum on-off capacity
120 mW
Use Class CB Scheme (IEC 60947-5-1)
AC15, 3 A/250V (N/O contact)
DC13, 2 A/24V (N/O contact)
Connection Mode
in-line connection
stripping length
8mm
Rigid conductor cross section
0.14 mm² ... 1.5 mm²
Flexible Wire Cross Section
0.14 mm² ... 1.5 mm²
0.14 mm² ... 1.5 mm² (cold press head with plastic sleeve)
0.14 mm² ... 1 mm² (sleeve with plastic insulating sleeve, two wires on the two-position terminal)
