Phoenix RIF-2-RPT-LDP-24DC/4X21 AU-Relay Module 2908332, pre-installed relay module with plug-in interface, including relay base, high-power contact relay (hard gold plated) and bracket. Contact type: 4 changeover contacts. Input voltage: 24V DC
Product Type
Relay Module
Product Series
RIFLINE complete
Application
General
Mode of operation
100% operating factor
mechanical life
about 2x 107times
insulation characteristics
insulation
Foundation Isolation
Overvoltage Category
II
pollution level
2
Data Management Status
Last data maintenance date
20.03.2025
rated conditions
1.01W
test voltage (coil/contact)
2.5 kVrms(50Hz,1 min, coil/contact)
test voltage (contact/contact)
2 kVrms(50Hz,1 min, contact/contact)
Rated insulation voltage
250V AC
Rated overvoltage
2.5 kV
coil side
Rated input voltage UN
24V DC
Input Voltage Range
19.2V DC ... 30V DC (20 °C)
to UNas reference
See Graph
drives and functions
monostable
drive (polarity)
polarization
UN
42 mA
Typical Response Time
13 ms
Typical release time
14 ms
protection circuit
freewheeling diode
Status Display
LED (yellow)
switching
Contact Type
4 PDT
Switch Contact Type
Single contact
Contact Material
AgNi, hard gold plating
Considerations
when the limit values given are exceeded, the gold plating is destroyed. If you continue to use, the highest value of the high power relay is applicable. Compared with the use of power contacts alone, its life will be reduced.
maximum switching voltage
30V AC
36V DC
Minimum Switching Voltage
2V (24 mA)
limit continuous current
50 mA
Maximum impact current
50 mA
minimum switching current
2 mA (24 V)
Maximum power rating (resistive load)
1.2W (24V DC)
Minimum on-off capacity
48 mW
switching: when the gold plating layer is destroyed
Considerations
If the gold plating is damaged, the following values are applicable.
Contact Material
AgNi
maximum switching voltage
250V AC/DC
Minimum Switching Voltage
5V (when 24 mA)
limit continuous current
6 A
Maximum impact current
16 A (20 ms, normally open contact)
minimum switching current
5 mA (24 V)
Maximum power rating (resistive load)
144W (24V DC)
124W (available for 48V DC)
108W (available for 60V DC)
52W (available for 110V DC)
48W (available for 220V DC)
1500 VA (available for 250V AC)
switch capacity
2 A (24V, DC13)
0.22 A (120V, DC13)
0.11 A (250V, DC13)
1.5 A (24V, AC15)
1.5 A (120V, AC15)
1 A (240V, AC15)
Connection Mode
in-line connection
stripping length
8mm
Rigid conductor cross section
0.14 mm² ... 1.5 mm²
Flexible Wire Cross Section
0.14 mm² ... 1.5 mm²
0.14 mm² ... 1.5 mm² (cold press head with plastic sleeve)
0.14 mm² ... 1 mm² (sleeve with plastic insulating sleeve, two wires on the two-position terminal)
