Phoenix MINI MCR-EX-SD-16-50-LFD-solenoid driver 1175902,Ex I-solenoid driver used to control the inherent safety solenoid valve in potentially explosive areas. No-load voltage: 16V DC, Current limit: 50 mA, Standard configuration, Line fault detection, Safety Integrity Level (SIL, IEC 61508): 3, Screw connection
Product Type
Electromagnetic driver
Product Series
MINI Analog Pro
Electrical characteristics
Suction time
< 50 ms
Line Monitoring
Line Fault Detection
electrical isolation
Overvoltage Category
II (≤ 5000 m)
pollution level
2 (≤ 5000 m)
electrically isolated input/power supply IEC/EN 61010-1
Standards/Regulations
IEC/EN 61010-1
Rated insulation voltage
250Vrms
Test Voltage
2.5 kV AC (50 Hz, 60 s)
insulation
Double/reinforced insulation
galvanically isolated output/power supply, input IEC/EN 61010-1
Standards/Regulations
IEC/EN 61010-1
Rated insulation voltage
300Vrms
Test Voltage
2.5 kV AC (50 Hz, 60 s)
insulation
Double/reinforced insulation
galvanically isolated output/input, power supply IEC/EN 60079-11
Standards/Regulations
IEC/EN 60079-11
Rated insulation voltage
265Vrms
galvanically isolated output/input, power supply IEC/EN 60079-7
Standards/Regulations
IEC/EN 60079-7
Rated insulation voltage
251Vrms
power supply
Rated supply voltage
24V DC
Supply Voltage Range
19.2V DC ... 30V DC (24V DC,-20 % ... +25 %)
power consumption
< 1.4W
input data
signals: logic
Input Number
1
toggle level "0" signal
0V DC ... 5V DC
Toggle Level "1" Signal
15V DC ... 30V DC
input current
< 3 mA
input impedance
> 1 MΩ (high resistance in case of line fault at output)
Line Fault Detection
< 25 Ω (short circuit)
> 10 k Ω (line break)
Output Data
signal: error message output
Output Signal Type
Transistor output through T-BUS
signals: voltage
Output Description
Ingenically safe
outputs
1
output voltage
≥ 10.7V DC (50 mA)
output resistance
≥ 103Ω (internal resistance RI )
Current Limit
> 50 mA (with line fault detection)
response time
< 20 ms
No-load voltage
> 16V DC
Short-circuit protection
is
Line Fault Detection
> 10 k Ω (line break)
< 25 Ω (short circuit)
activated/deactivated via DIP switch
connection data
Connection Mode
screw connection
stripping length
10mm
thread
M3
Rigid conductor cross section
0.2 mm² ... 1.5 mm² (with cold press head)
0.14 mm² ... 2.5 mm² (without cold head)
Flexible Wire Cross Section
0.14 mm² ... 2.5 mm²
Attachable Guide Cross Section AWG
24 ... 12 (flexible)
Tightening torque
0.5 Nm ... 0.6 Nm
