Phoenix TRIO-PS-2G/1500DC/24DC/8-DC/DC converter 1075240, TRIO POWER DC/DC converter with plug-in connection, primary switching mode, suitable for DIN rail installation, input: 1,500V DC, output: 24V DC/8 A
| DC operation |
| Rated input voltage range |
600V DC ... 1500V DC |
| Input Voltage Range |
600V DC ... 1500V DC -15 % ... +10% |
| Wide Input |
No |
| DC input voltage range |
600V DC ... 1500V DC -15 % ... +10% |
| maximum dielectric strength |
≤ 1800V DC 1 s |
| National Grid Typical Voltage |
1500V DC |
| 600V DC |
| Supply Voltage |
DC |
| impulse current integral (I2t) |
Typical 0.15 A2s |
| power consumption |
Typical 0.35 A (600V DC) |
| Typical 0.145 A (1500V DC) |
| recommend use |
1 A (gPV) |
| recommend |
1500V DC |
| efficiency |
Typical 91.5 % (600V DC) |
| Typical 90.9 % (900V DC) |
| 89% typical (1500V DC) |
| Rated output voltage |
24V DC ±1% |
| output voltage (USet) setting range |
24V DC ... 28V DC (> 24V DC, stable capacity limit) |
| Rated output current (IN) |
8 A |
| Attenuation |
> 60°C ... 70°C (2.5 %/K) |
| feedback voltage resistance |
≤ 35V DC |
| output |
≤ 30V DC |
| control deviation |
<1% (load change, static 10%... 90%) |
| <3% (dynamic load change 10%... 90%, 10Hz) |
| < 0.1 % (input voltage variation is ± 10 %) |
| residual wave |
< 40 mVSS(Ripple) |
| < 50 mVSS(Noise) |
| Short-circuit protection |
is |
| Anti-aircraft turn |
is |
| output power |
192W |
| maximum no-load power consumption |
< 9W |
| Maximum rated load power loss |
< 24W |
| rise time |
≤ 30 ms (UOUT(10%... 90%)) |
| and connect |
Yes, for redundancy and increased capacity |
| Concatenation |
No |
| signal: DC OK |
| Continuous load current |
100 mA |
| signal relay 13/14 |
| Default (Value) |
closed |
| digital quantity |
30V AC 30V DC 100 mA |
| Input |
| Connection Mode |
in-line connection |
| Minimum cross section of rigid conductor |
1 mm² |
| Maximum cross section of rigid conductor |
4 mm² |
| flexible lead |
1 mm² |
| flexible conductor |
2.5 mm² |
| Single conductor/flexible connection point, cold press head with plastic sleeve, minimum |
1 mm² |
| Single wire/flexible connection point, cold press head with plastic sleeve, maximum |
2.5 mm² |
| single-conductor/flexible connection point, cold press head without plastic sleeve, minimum |
1 mm² |
| Single wire/flexible connection point, cold press head with plastic sleeve, maximum |
2.5 mm² |
| Minimum Wire Cross Section AWG |
18 |
| Maximum conductor cross section AWG |
12 |
| stripping length |
10mm |
