Phoenix UNO-PS/1AC/12DC/30W-power supply 2902998, UNO POWER power supply for DIN rail installation, primary switching mode, input: 1 phase, output: 12V DC/30W
AC operation
Rated input voltage range
100V AC ... 240V AC
Input Voltage Range
85V AC ... 264V AC
AC input voltage range
85V AC ... 264V AC
Supply Voltage
AC
Impulse current
< 25 A (typical)
impulse current integral (I2t)
< 0.3 A2s (typical)
AC frequency range
50Hz ... 60Hz-10%... + 10%
frequency range (fN)
50Hz ... 60Hz ± 10%
grid buffer time
> 20 ms (120V AC)
> 110 ms (230V AC)
power consumption
Typical 0.8 A (100V AC)
Typical 0.4 A (240V AC)
Rated power consumption
71.7 VA
protection circuit
transient surge protection; varistor
power factor (cos phi)
0.48
Typical Response Time
< 1 s
input fuse
2 A (slow fuse, internal)
recommend use
6 A ... 16 A (characteristics B, C, D, K)
efficiency
86% typical (120V AC)
87% typical (230V AC)
output characteristics
HICCUP
Rated output voltage
12V DC
Rated output current (IN)
2.5 A (-25°C ... 55 °C)
Attenuation
55°C ... 70°C (2.5 %/K)
feedback voltage resistance
< 25V DC
output
≤ 25V DC
control deviation
<1% (load change, static 10%... 90%)
<3% (dynamic load change 10%... 90%, 10Hz)
< 0.1 % (input voltage variation is ± 10 %)
residual wave
< 30 mVSS(rated value)
Short-circuit protection
is
output power
30W
maximum no-load power consumption
< 0.3W
Maximum rated load power loss
< 4.6W
rise time
< 0.5 s (UOUT(10%... 90%))
response time
< 2 ms
and connect
Yes, for redundancy and increased capacity
Concatenation
is
Input
Connection Mode
screw connection
Minimum cross section of rigid conductor
0.2 mm²
Maximum cross section of rigid conductor
2.5 mm²
Minimum cross section of flexible lead
0.2 mm²
flexible conductor
2.5 mm²
Single conductor/flexible connection point, cold press head with plastic sleeve, minimum
0.2 mm²
Single wire/flexible connection point, cold press head with plastic sleeve, maximum
2.5 mm²
single-conductor/flexible connection point, cold press head without plastic sleeve, minimum
