ꄴPrevious： Phoenix PLC-ESK GY-Power Terminal Block 2966508
ꄲNext： Phoenix PLC-2RPT-24DC/1-Relay Module 2901639

Phoenix PLC-2RSC-24DC/ 1-Relay module 2987309, PLC-INTERFACE with two independent relays, including PLC-BSC.../21 base terminals, connected by screws and with two integrated relays, power contacts, for Installation on DIN rail NS 35/7.5, 2 x 1 normally open contacts, input voltage 24V DC

Product Type Relay Module
product series PLC-INTERFACE
Application two built-in relays
Mode of operation 100% operating factor
mechanical life 2x 107Switch Times
insulation characteristics: electrical clearance and creepage distance between power supply circuits
insulation Foundation Isolation
Overvoltage Category III
pollution level 2
Data Management Status
Last data maintenance date 21.03.2025

rated conditions 0.17W
test voltage (coil/contact) 3 kV AC (50Hz,1 min, coil/contact)
test voltage (contact/contact) 3 kV AC (50Hz,1 minute, contact/contact)
Electrical clearance and creepage distance between power supply circuits
Rated insulation voltage 250V AC
Rated overvoltage 4 kV

coil side
Rated input voltage UN 24V DC
Input Voltage Range 18V DC ... 33.6V DC (20 °C)
drives and functions monostable
drive (polarity) polarization
UN 7 mA
Typical Response Time 4 ms
Typical release time 6 ms
protection circuit polarity protection; polarity protection diode
backup diode; freewheeling diode
Operating voltage display yellow LED

switching
Contact Type 2 N/O contacts
Switch Contact Type single contact
Remarks on switch contacts two built-in relays
Contact Material AgNi
maximum switching voltage 250V AC
30V DC
Minimum Switching Voltage 24V AC/DC
limit continuous current 3.5 A
Maximum starting current 5 A
minimum switching current 5 mA
Maximum power rating (resistive load) 84W (24V DC)
24W (available for 48V DC)
24W (available for 60V DC)
31W (available for 110V DC)
46W (available for 220V DC)
875 VA (available for 250V AC)
2902968
넳 넲

Phoenix PLC-2RSC-24DC/ 1-Relay Module 2987309

Product Center

PRODUCT CENTER

▼