Phoenix PLC-OPT-125DC/300DC/1-solid state relay module 2900390,PLC-INTERFACE, integrated solid state relay connected by butterfly spring, can be installed on NS 35/7,5 DIN rail, input: 125V DC, output: 12 - 300V DC/1 A
| Product Type | Solid State Relay Module |
| Product Series | PLC-INTERFACE |
| Application | with built-in solid state relay |
| Mode of operation | 100% operating factor |
| Insulation Characteristics: Standards/Regulations | |
| insulation | Foundation Isolation |
| Overvoltage Category | III |
| pollution level | 2 |
| Data Management Status | |
| Last data maintenance date | 20.03.2025 |
| rated conditions | 0.75W |
| Standards/Regulations | |
| Rated insulation voltage | 300V |
| Rated overvoltage | 4 kV |
| Rated input voltage UN | 125V DC |
| relative to UNinput voltage range | 0.8 ... 1.1 |
| Input Voltage Range | 100V DC ... 138V DC |
| UN | 6 mA |
| transmission frequency | 50Hz |
| Name | Output Data |
| Contact Type | 1 N/O contact |
| Digital Output Design | electronic |
| Output Voltage Range | 12V DC ... 300V DC (When the voltage between the same connection terminals of two adjacent modules is greater than 250V(L1, L2, L3), a spacer PLC-ATP must be used. FBST 8-PLC... or... FBST 500... for equipotential bridging) |
| limit continuous current | 1 A (see temperature load curve) |
| Voltage drop at maximum limited continuous current | < 500 mV |
| protection circuit | polarity protection; polarity protection diode |
| Surge protection; Varistor |
| Connection Mode | in-line connection |
| stripping length | 10mm |
| Rigid conductor cross section | 0.14 mm² ... 2.5 mm² |
| Flexible Wire Cross Section | 0.14 mm² ... 2.5 mm² |
| 0.2 mm² ... 2.5 mm² (single sleeve) | |
| 2x 0.5 mm² ... 1 mm² (TWIN sleeve) | |
| Attachable Guide Cross Section AWG | 26 ... 14 |
Phoenix PLC-OPT-125DC/300DC/1-Solid State Relay Module 2900390
