Phoenix PLC-RPT-120UC/21/SO46-relay module 1125988, can resist the PLC-INTERFACE of interference current/voltage on the control side. Including PLC-BPT-120UC/21/SO46 base terminal, using plug-in connection, with plug-in miniature relay equipped with power contacts up to 6 A, 1 change-over contact, 120V AC input voltage
| Product Type | Relay Module |
| Product Series | PLC-INTERFACE |
| Application | anti-interference filter |
| Mode of operation | 100% operating factor |
| mechanical life | 2x 107Switch Times |
| insulation characteristics: electrical clearance and creepage distance between power supply circuits | |
| insulation | safety isolation, reinforced insulation |
| Overvoltage Category | III |
| pollution level | 3 |
| Data Management Status | |
| Last data maintenance date | 21.03.2025 |
| rated conditions | 0.84W |
| test voltage (coil/contact) | 4 kVrms(50Hz,1 min, coil/contact) |
| Electrical clearance and creepage distance between power supply circuits | |
| Rated insulation voltage | 250V AC |
| Rated overvoltage | 6 kV |
| coil side | |
| Rated input voltage UN | 120V AC |
| 110V DC | |
| Input Voltage Range | 93.6V AC ... 168V AC (20 °C) |
| 85.8V DC ... 154V DC (20 °C) | |
| rated voltage ("hot" plug electromagnetic relay) | 60V DC |
| mains frequency | 50/60Hz |
| drives and functions | monostable |
| drive (polarity) | polarization |
| UN | 7 mA (50 Hz) |
| 8 mA (60 Hz) | |
| Typical Response Time | 7 ms |
| Typical release time | 20 ms |
| regular release voltage | 50V AC |
| protection circuit | Bridge Rectifier |
| RC element | |
| Status Display | LED (yellow) |
| switching | |
| Contact Type | 1 changeover contact |
| Switch Contact Type | Single contact |
| Contact Material | AgSnO, hard gold plating |
| maximum switching voltage | 250V AC/DC |
| Minimum Switching Voltage | 5V (100 mA) |
| limit continuous current | 6 A |
| Maximum impact current | 10 A (4 s) |
| minimum switching current | 10 mA (12 V) |
| short-circuit current | 200 A (condition short-circuit current) |
| Maximum power rating (resistive load) | 140W (24V DC) |
| 20W (48V DC) | |
| 18W (60V DC) | |
| 23W (110V DC) | |
| 40W (220V DC) | |
| 1500 VA (250V AC) | |
| Minimum on-off capacity | 0.12W |