Phoenix PLC-RSC- 24DC/PMC T200/21HC-Timer Relay 2307293, Combined Timing Relay, Pre-moving Contact with Plug-in Micro Relay and Screw Connection

Product Type Relay Module
product series PLC-INTERFACE
Mode of operation 100% operating factor
mechanical life about 2x 107times
insulation characteristics: electrical clearance and creepage distance
insulation Safety isolation, enhanced isolation (insulation board PLC-ATP should be installed between adjacent modules to ensure safety).
Overvoltage Category III
pollution level 3
Data Management Status
Last data maintenance date 19.03.2025

rated conditions 0.4W

coil side
Rated input voltage UN 24V DC
Input Voltage Range 19.2V DC ... 26.4V DC (20 °C)
rated voltage ("hot" plug electromagnetic relay) 24V DC
UN 15 mA (relay ON)
4.3 mA (relay OFF)
Typical Response Time 7 ms
Typical release time 200 ms +130 ms (UN)
protection circuit surge protection; freewheeling diode
Operating voltage display yellow LED

switching
Contact Type Single contact, 1 changeover contact
Switch Contact Type single contact
Contact Material AgNi, hard gold plating
maximum switching voltage 250V AC/DC (When the voltage between the same terminal blocks of two adjacent modules is greater than 250V(L1, L2, L3), the partition PLC-ATP must be used.)
Minimum Switching Voltage 12V AC/DC
limit continuous current 10 A
Maximum starting current 16 A
minimum switching current 100 mA
switching: when the gold plating layer is destroyed
Maximum power rating (resistive load) 240W (24V DC)
144W (available for 48V DC)
48W (available for 60V DC)
50W (available for 110V DC)
80W (available for 220V DC)
4000W (available for 250V AC)

Connection Mode screw connection
stripping length 8mm
thread M3
Rigid conductor cross section 0.14 mm² ... 2.5 mm²
Flexible Wire Cross Section 0.14 mm² ... 2.5 mm²
0.2 mm² ... 2.5 mm² (single sleeve)
2x 0.5 mm² ... 1.5 mm² (TWIN sleeve)
2967060

Phoenix PLC-RSC- 24DC/PMC T200/21HC-Timer Relay 2307293

Product Center

PRODUCT CENTER