Phoenix RIF-1-RPT-LV-120AC/1X21-Relay Module 2903340, a prefabricated relay module with in-line connection, including: relay base, power contact relay, plug-in display/interference suppression module and fixed bracket. Contact switching type: 1 changeover contact. Input voltage: 120V AC
| Product Type |
Relay Module |
| Product Series |
RIFLINE complete |
| Application |
General |
| Mode of operation |
100% operating factor |
| mechanical life |
about 107Switch Times |
| insulation characteristics |
| insulation |
input and output |
| changeover contacts |
| Overvoltage Category |
III |
| pollution level |
2 |
| Data Management Status |
| Last data maintenance date |
20.03.2025 |
| service life, electrical |
See Graph |
| rated conditions |
0.96W |
| test voltage (coil/contact) |
4 kVrms(50Hz,1 min, coil/contact) |
| Rated insulation voltage |
250V AC |
| Rated overvoltage |
6 kV (input/output) |
| 4 kV (between changeover contacts) |
| coil side |
| Rated input voltage UN |
120V AC |
| Input Voltage Range |
96V AC ... 138V AC (20 °C) |
| to UNas reference |
See Graph |
| mains frequency |
50/60Hz |
| drives and functions |
monostable |
| drive (polarity) |
polarization |
| UN |
8 mA |
| Typical Response Time |
3 ms ... 12 ms |
| Typical Release Time Range |
3 ms ... 20 ms |
| coil voltage |
120V AC |
| protection circuit |
varistor |
| Operating voltage display |
yellow LED |
| switching |
| Contact Type |
1 changeover contact |
| Switch Contact Type |
Single contact |
| Contact Material |
AgNi |
| maximum switching voltage |
250V AC/DC |
| Minimum Switching Voltage |
12V (10 mA) |
| limit continuous current |
10 A (see graph) |
| Maximum impact current |
25 A (20 ms, normally open contact) |
| minimum switching current |
10 mA (12 V) |
| Maximum power rating (resistive load) |
240W (24V DC) |
| 58W (48V DC) |
| 48W (60V DC) |
| 50W (110V DC) |
| 80W (220V DC) |
| 2500 VA (250V AC) |
| Use Class CB Scheme (IEC 60947-5-1) |
AC15, 1.5 A/240V (N/O contact) |
| AC15, 3 A/250V (normally closed contact) |
| DC13, 2 A/24V (normally closed contact) |
| DC13, 0.2 A/250V (N/O contact) |
| Connection Mode |
in-line connection |
| stripping length |
8mm |
| Rigid conductor cross section |
0.14 mm² ... 1.5 mm² |
| Flexible Wire Cross Section |
0.14 mm² ... 1.5 mm² |
| 0.14 mm² ... 1.5 mm² (cold press head with plastic sleeve) |
| 0.14 mm² ... 1 mm² (sleeve with plastic insulating sleeve, two wires on the two-position terminal) |
| Attachable Guide Cross Section AWG |
26 ... 16 (rigid) |
| 26 ... 16 (flexible) |
| Product Size |
| width |
16mm |
| height |
96mm |
| depth |
75mm |
| Drilling |
| diameter |
3.2mm |
