Phoenix RIF-2-RPT-LV-24AC/2X21-Relay Module 2903313, a prefabricated relay module with in-line connection, including: relay base, power contact relay, plug-in display/interference suppression module and fixed bracket. Contact switching type: 2 changeover contacts. Input voltage: 24V AC
| Product Type |
Relay Module |
| product series |
RIFLINE complete |
| Application |
General |
| Mode of operation |
100% operating factor |
| mechanical life |
about 2x 107times |
| insulation characteristics |
| insulation |
Foundation Isolation |
| Overvoltage Category |
III |
| pollution level |
2 (rated voltage 230/400V) |
| Data Management Status |
| Last data maintenance date |
20.03.2025 |
| rated conditions |
1.58W |
| test voltage (coil/contact) |
2.5 kVrms(50Hz,1 min, coil/contact) |
| test voltage (contact/contact) |
2.5 kVrms(50Hz,1 min, contact/contact) |
| Rated insulation voltage |
250V AC |
| Rated overvoltage |
4 kV |
| coil side |
| Rated input voltage UN |
24V AC |
| Input Voltage Range |
19.2V AC ... 28.8V AC (20 °C) |
| to UNas reference |
See Graph |
| mains frequency |
50/60Hz |
| drives and functions |
monostable |
| drive (polarity) |
polarization |
| UN |
66 mA |
| Typical Response Time |
5 ms ... 15 ms |
| Typical Release Time Range |
5 ms ... 20 ms |
| coil voltage |
24V AC |
| protection circuit |
varistor |
| Operating voltage display |
yellow LED |
| switching |
| Contact Type |
2 changeover contacts |
| Switch Contact Type |
single contact |
| Contact Material |
AgNi |
| maximum switching voltage |
250V AC/DC |
| Minimum Switching Voltage |
5V (24 mA) |
| limit continuous current |
8.5 A (see graph) |
| Maximum impact current |
30 A (20 ms, normally open contact) |
| minimum switching current |
5 mA (24 V) |
| Maximum power rating (resistive load) |
204W (24V DC) |
| 124W (available for 48V DC) |
| 108W (available for 60V DC) |
| 52W (available for 110V DC) |
| 48W (available for 220V DC) |
| 2125 VA (available for 250V AC) |
| switch capacity |
2 A (24V, DC13) |
| 0.22 A (120V, DC13) |
| 0.11 A (250V, DC13) |
| 3 A (120V, AC15) |
| 1.5 A (240V, AC15) |
| Connection Mode |
in-line connection |
| stripping length |
8mm |
| Rigid conductor cross section |
0.14 mm² ... 1.5 mm² |
| Flexible Wire Cross Section |
0.14 mm² ... 1.5 mm² |
| 0.14 mm² ... 1.5 mm² (cold press head with plastic sleeve) |
| 0.14 mm² ... 1 mm² (sleeve with plastic insulating sleeve, two wires on the two-position terminal) |
| Attachable Guide Cross Section AWG |
26 ... 16 (rigid) |
| 26 ... 16 (flexible) |
