Phoenix PSR-SPP-230UC/ESAM4/3X1/1X2/B-safety relay 2901429, safety relay for emergency stop and safety door monitoring, meeting SIL 3 or Cat. 4 category, PL e(EN ISO 13849 standard), single Channel or dual channel operation, 3 enabled current paths, nominal input voltage: 230V AC/DC, pluggable in-line terminals
Product Type
safety relay
Product Series
PSRclassic
Application
Emergency stop button
safety door
control
Single and Dual Channel
mechanical life
about 107Switch Times
Relay Model
Electromechanical relay with mechanical interlocking contacts according to IEC/EN 61810-3
insulation characteristics
Overvoltage Level
III
pollution level
2
rated conditions
2.88W
Rated operating mode
100% Eligible
Rated insulation voltage
250V AC
rated overvoltage/insulation
4 kV/basic insulation (safety isolation, reinforced insulation and 6 kV between A1-A2/logic/normally open safety contact output and display output)
Overview
Rated control circuit supply voltage US
230V AC/DC -15 % / +10%
US
2W
Rated control supply current IS
22 mA
input/start and feedback circuit voltage
~ 24V DC
Typical Response Time
40 ms (manual start)
typical startup time (Us)
330 ms (when controlled via A1)
Typical release time
150 ms (when controlled via A1)
20 ms (when controlled by s11/S12 and S21/S22)
parallel
∞
Recovery Time
1 s
Maximum switching frequency
0.5Hz
protection circuit
Surge protection; Varistor 275VRMS(A1-A2)
Surge protection; Varistor
Allowable Total Conductor Resistance
50 Ω
Contact Type
3 normally open safety contact outputs
1 signal transmission current path
Contact Material
AgSnO2,+ 0.2 µm Au
maximum switching voltage
250V AC/DC
Minimum Switching Voltage
10V AC/DC
limit continuous current
6 A (normally open safety contact output)
5 A (signal transmission current path)
Maximum impact current
6 A
Minimum impulse current
10 mA
the square of the total current value
72 A2(ITH2= I12+ I22+ I32)
Maximum power rating (resistive load)
144W (24VDC,t=0ms)
230W (48VDC,t=0ms)
68W (110VDC,t=0ms)
88W (220VDC,t=0ms)
2000 VA (250V AC,τ = 0 ms)
Maximum power rating (inductive load)
48W (24V DC, τ = 40 ms)
40W (48V DC,τ = 40 ms)
35W (110V DC,τ=40ms)
33W (220V DC,τ=40ms)
Minimum on-off capacity
100 mW
on-off capacity (360/h cycle)
6 A (24V DC)
5 A (230V AC)
on-off capacity (3600/h cycle)
3 A (24V (DC13))
3 A (230V (AC 15))
output fuse
10 A gL/gG NEOZED (normally open safety contact output)
6 A gL/gG NEOZED (signal transmission current path)
connection technology
pluggable
is
Wire Connection
Connection Mode
in-line connection
Rigid conductor cross section
0.2 mm² ... 1.5 mm²
Flexible Wire Cross Section
0.2 mm² ... 1.5 mm²
Flexible conductor cross-section, with sleeve, with plastic insulation sleeve
