Phoenix QUINT4-PS/1AC/12DC/15-power supply 2904608,QUINT POWER power supply, primary switching mode, freely selectable output characteristic curve, SFB (selective fusing) technology, and NFC interface, input: 1 phase, output: 12V DC/15 A
| Control Input (Configurable) Rem |
output power ON/OFF (SLEEP MODE) |
| Default (Value) |
Output power ON (>40 kΩ/24V DC/Open bridge between Rem and SNew) |
| AC operation |
| Rated input voltage range |
100V AC ... 240V AC |
| Input Voltage Range |
100V AC ... 240V AC -15 % ... +10% |
| maximum dielectric strength |
300V AC 60 s |
| National Grid Typical Voltage |
120V AC |
| 230V AC |
| Supply Voltage |
AC |
| Impulse current |
Typical 15 A (at 25°C) |
| impulse current integral (I2t) |
< 0.6 A2s |
| Surge current limit |
15 A (after 1 ms) |
| AC frequency range |
50Hz ... 60Hz-10%... + 10% |
| frequency range (fN) |
50Hz ... 60Hz-10%... + 10% |
| 16.7Hz (in accordance with EN 50163) |
| grid buffer time |
Typical 55 ms (120V AC) |
| Typical 56 ms (230V AC) |
| power consumption |
2.4 A (100V AC) |
| 1.9 A (120V AC) |
| 1.1 A (230V AC) |
| 1.1 A (240V AC) |
| Rated power consumption |
221 VA |
| protection circuit |
transient surge protection; varistor, gas discharge tube |
| Suction time |
< 1 s |
| Typical Response Time |
300 ms (from SLEEP MODE) |
| input fuse |
8 A (slow fuse, internal) |
| recommend use |
10 A ... 16 A (characteristics B, C, D, K or similar) |
| PE discharge current |
< 3.5 mA |
| 0.7 mA (264V AC,60 Hz) |
| DC operation |
| Rated input voltage range |
110V DC ... 250V DC |
| Input Voltage Range |
110V DC ... 250V DC -18 % ... +40% |
| Supply Voltage |
DC |
| power consumption |
2.2 A (110V DC) |
| 1 A (250V DC) |
| efficiency |
Typical 91.2 % (120V AC) |
| 92% typical (230V AC) |
| Rated output voltage |
12V DC |
| output voltage (USet) setting range |
12V DC ... 15V DC (constant capacity) |
| Rated output current (IN) |
15 A |
| Static Boost (IStat.Boost) |
17.5 A |
| Dynamic Boost (IDyn.Boost) |
20 A (5 s) |
| selective fusing (ISFB) |
60 A (15 ms) |
| Type of thermal magnetic circuit breaker |
A1...A6 / B2...B6 / C1...C2 / Z1...Z6 |
| Attenuation |
> 60°C ... 70°C (2.5 %/K) |
| feedback voltage resistance |
≤ 25V DC |
| output |
≤ 18V DC |
| control deviation |
< 0.5 % (static load change 10% ... 90%) |
| <4% (dynamic load change 10% ... 90%,(10Hz)) |
| < 0.25 % (input voltage variation is ± 10 %) |
