Phoenix MINI MCR-SL-NAM-2RNO-switch amplifier 2864105, configurable NAMUR switch amplifier, can be used for proximity switches, floating switch contacts and switch contacts of resistive circuits. 2 N/O contacts on the output side with screw wiring
Product Type
isolation amplifier
Product Series
MINI Analog
Channels
1
configuration
DIP switch
insulation characteristics
Overvoltage Category
II
pollution level
2
Function
configuration
DIP switch
Rated insulation voltage
150V AC (input/relay output (reinforced insulation))
150V AC (power supply/relay output (reinforced insulation))
150V AC (relay output 1/relay output 2 (reinforced insulation))
30V AC (input/power)
50V DC (input/power)
electrical isolation
reinforced insulation conforming to IEC 61010-1
galvanic isolation between input and output
is
Test voltage, input/output/power supply
1.5 kV AC (50 Hz, 60 s)
power supply
Name
power supply
Rated supply voltage
24V DC
Supply Voltage Range
19.2V DC ... 30V DC (DIN rail bus connector (ME 6,2 TBUS-2 1,5/5-ST-3,81 GN, order number 2869728) can be used to bridge the power supply. Can be stuck to a 35mm DIN rail conforming to the EN60715 standard))
Maximum current consumption
< 25 mA
power consumption
< 600 mW
signal: NAMUR
Input Number
1
valid input source
NAMUR proximity switch sensor (IEC/EN 60947-5-6)
Floating switch contact
Switch contacts with resistor circuit
switch threshold "0" signal current
< 1.2 mA (disabled)
switch threshold "1" signal, current
> 2.1 mA (ON)
Line Fault Detection
> 6 mA (short circuit)
< 0.35 mA (line break)
activated/deactivated via DIP switch
No-load voltage
8.2V DC ±10%
2864422
넳넲
Phoenix MINI MCR-SL-NAM-2RNO-Switching Amplifier 2864105
