Phoenix MINI MCR-SL-PT100-LP-NC-temperature measurement transmitter 2810308, configurable loop-powered temperature transmitter, used for Pt 100 temperature sensor, configured by DIP switch, with screw connection, not pre-configured
| Product Type | temperature measurement transmitter |
| product series | MINI Analog |
| configuration | DIP switch |
| insulation characteristics | |
| Overvoltage Category | II |
| pollution level | 2 |
| Function | |
| configuration | DIP switch |
| Linearity Error | < 0.05 % (for all ranges) |
| rated conditions | < 42 mW |
| step response (0-99%) | < 200 ms |
| maximum temperature coefficient | < 0.02 %/K |
| set range | ((90 K/set measuring range [K]) +0.05)% |
| Full-scale transmission fault | ≤ 0.25% |
| Electrical isolation input/output/power supply | |
| Rated insulation voltage | 30V AC |
| 50V DC | |
| Test Voltage | 1.5 kV AC (50 Hz, 60 s) |
| insulation | foundation isolation conforming to IEC/EN 61010 |
| power supply | |
| Name | loop power supply |
| Supply Voltage Range | 12V DC ... 30V DC |
| Maximum current consumption | < 4.5 mA (no signal current) |
| power consumption | < 150 mW (no signal current) |
| signal | |
| Input Number | 1 |
| measurement | |
| configurable/programmable | Yes, not configured |
| Available Sensor Types (RTDs) | Pt 100 (IEC 60751/EN 60751) |
| Temperature measurement range | minimum 50 K |
| Sensor Type: | -150°C ... 300°C (configurable) |
| Sensor Input Current | 1 mA (constant) |
| Allowable total conductor resistance | 10Ω (per cable) |
| connection system | 2,3,4 lines |
| fault monitoring limit (short circuit) | < 30 Ω |
| fault monitoring limit (range too short) | 30 Ω ≤ (starting range -2.5% range) |
| fault monitoring limit (out of range) | (end range +2.5% range) ≤ approx. 254 Ω |
| FAULT MONITORING LIMITS (WIRE DAMAGE) | > about 254 Ω |
Phoenix MINI MCR-SL-PT100-LP-NC-temperature measurement transmitter 2810308
