ꄴPrevious： Phoenix NEARFI DEETH R-Inductive coupler 1234234
ꄲNext： Phoenix MCR-SL-D-U-I-digital display table 2864011

Phoenix NEARFI D ETH B- inductive coupler 1234232,NearFi base station contactless power supply and real-time Ethernet coupler, 100 Mbps, range ≤ 40mm,M12 screw connection, IP65, can be combined with NEARFI D ETH R. Not compatible with NEARFI 2000 (new product)

Product Type inductive coupler
Application Ethernet
MTTF 239 years (SN 29500 standard, temperature 25°C, duty cycle 21%)
155 years (SN 29500 standard, temperature 40°C, duty cycle 34.25%)
81 years (SN 29500 standard, temperature 40°C, duty cycle 100%)
insulation characteristics
Overvoltage Category II
pollution level 2

rated conditions 4.68W
Power
Supply Voltage Range 19V DC ... 30V DC
Typical current consumption ≤ 195 mA (24V DC,25 °C)
Impulse current ≤ 0.25 A (20 ms at 24V DC without remote coupler)
protection circuit transient protection, polarity protection

Power
Connection Mode M12 Pin, A- coded

data: Ethernet interface, 100Base-T(X), IEEE 802.3 compliant
transmission speed 100 Mbps
Connection Mode M12 hole type, D code
Connection Method Considerations auto-negotiation and auto-crossover, fast start (FSU,<500 ms)
Typical bit error rate≤ 10-12
Channels 1
Transmission Length 100 m (shielded twisted pair)
transmission medium copper cable
Supported Protocols protocol transparency: PROFINET, PROFINET IRT, PROFIsafe, EtherCAT®, Modbus/TCP, Powerlink, TSN, etc.
inductance
Suction time < 450 ms (ETH full-duplex operation mode)
minimum 0mm
≤ 20 mm (at 65°C)
≤ 40 mm (at 25°C)
center offset ± 20mm
can connect the wireless module 1 (remote coupler)
Wireless
can connect the wireless module 1 (remote coupler)
frequency 60 GHz
Frequency Range 57 GHz ... 64 GHz (data transmission)
transmission power < 10 mW (EIRP)
delay time ≤ 1 & micro;s (typical)
1234225
넳 넲

Phoenix NEARFI D ETH B- Inductive coupler 1234232

Product Center

PRODUCT CENTER

▼