Phoenix PSM-ME-RS232/TTY-P-interface converter 2744458, interface converter, convert RS-232 (V.24) to TTY, with electrical isolation, 2 channels, rail mounted

Product Type Interface Interface Converter
Application RS-232
TTY
MTBF 1989 (Telcordia standard, temperature 25°C,21% operation cycle (5 days a week, 8 hours a day))
410 years (Telcordia standard, 40°C,34.25% cycle (5 days a week, 12 hours a day))

electrical isolation VCC // V.24 (RS-232) // TTY
rated conditions 1.8W
test voltage data interface/power supply 2 kVrms(50 Hz,1 min)
2 kV AC
Test Voltage Data Interface 2 kV AC
Power
Supply Voltage Range 19.2V AC/DC ... 28.8V AC/DC
Rated supply voltage 24V AC/DC ± 20% (via plug-in COMBICON screw terminal block)
Typical current consumption 75 mA (24V DC)
protection circuit Surge protection; Suppressor diode

Power
Tightening torque 0.56 Nm ... 0.79 Nm

bit distortion <5%
bit delay < 3 &micro;s
signal Modbus
transmission channel 2(1/1)RxD, TxD, Full Duplex
data: RS-232 interface, according to ITU-T V.28, EIA/TIA-232, DIN 66259-1
serial transmission rate ≤ 19.2 kbps
Connection Mode D-SUB-9 male connector
Pin Distribution DTE/DCE switching through switches
Transmission Length 15 m (shielded twisted pair)
single wire/wiring point, flexible 0.2 mm² ... 2.5 mm²
AWG stranded wire, flexible 13
AWG Wire Minimum Cross Section, Flexible 24
Supported Protocols Transparency Agreement
data: TTY interface, 2 channels, according to DIN 66348-1
serial transmission rate ≤ 19.2 kbps
Connection Mode pluggable screw connection
Transmission Length 1000 m (shielded twisted pair)
single wire/wiring point, flexible 0.2 mm² ... 2.5 mm²
AWG stranded wire, flexible 13
AWG Wire Minimum Cross Section, Flexible 24
load/output load current output ≤ 500 Ω
impedance ≤ 117 Ω (output)
126 Ω (input)
output current 2x 20 mA ± 10% (loop current)
2744458

Phoenix PSM-ME-RS232/TTY-P-Interface Converter 2744458

Product Center

PRODUCT CENTER