Phoenix RIF-0-RPT-24DC/ 1AU-Relay Module 2903359, pre-installed relay module with plug-in connection, including: relay base (with pop-up device) and multi-layer gold-plated contact relay. Contact type: 1 normally open contact. Input voltage: 24V DC
| Product Type |
Relay Module |
| product series |
RIFLINE complete |
| Application |
General |
| Mode of operation |
100% operating factor |
| mechanical life |
about 2x 107times |
| insulation characteristics |
| insulation |
security isolation |
| Overvoltage Category |
III |
| pollution level |
2 |
| Data Management Status |
| Last data maintenance date |
20.03.2025 |
| service life, electrical |
See Graph |
| rated conditions |
0.22W |
| test voltage (coil/contact) |
4 kVrms(50Hz,1 min, coil/contact) |
| Rated insulation voltage |
250V AC |
| Rated overvoltage |
6 kV |
| coil side |
| Rated input voltage UN |
24V DC |
| Input Voltage Range |
19.2V DC ... 36V DC (20 °C) |
| to UNas reference |
See Graph |
| drives and functions |
monostable |
| drive (polarity) |
polarization |
| UN |
9 mA |
| Typical Response Time |
5 ms |
| Typical release time |
8 ms |
| coil voltage |
24V DC |
| protection circuit |
freewheeling diode |
| Operating voltage display |
yellow LED |
| switching |
| Contact Type |
1 N/O contact |
| Switch Contact Type |
single contact |
| Contact Material |
AgSnO, hard gold plating |
| maximum switching voltage |
30V AC |
| 36V DC |
| Minimum Switching Voltage |
100 mV (10 mA) |
| limit continuous current |
50 mA |
| Maximum impact current |
50 mA |
| minimum switching current |
1 mA (12 V) |
| Maximum power rating (resistive load) |
1.2W (24V DC) |
| Use Class CB Scheme (IEC 60947-5-1) |
AC15, 3 A/250V (N/O contact) |
| AC15, 1 A/250V (normally closed contact) |
| DC13, 1.5 A/24V (N/O contact) |
| DC13, 0.2 A/110V (N/O contact) |
| DC13, 0.1 A/220V (N/O contact) |
| switching: when the gold plating layer is destroyed |
| Considerations |
If the gold plating is damaged, the following values are applicable. |
| Contact Material |
AgSnO |
| maximum switching voltage |
250V AC/DC |
| Minimum Switching Voltage |
5V (at 100 mA) |
| limit continuous current |
6 A |
| minimum switching current |
10 mA (at 12V) |
| Maximum power rating (resistive load) |
140W (24V DC) |
| 20W (available for 48V DC) |
| 18W (available for 60V DC) |
| 23W (available for 110V DC) |
| 40W (available for 220V DC) |
| 1500 VA (available for 250V AC) |
| switch capacity |
2 A (24V, DC13) |
| 0.2 A (at 110V, DC13) |
| 0.1 A (220V, DC13) |
| 3 A (24V, AC15) |
| 3 A (120V, AC15) |
| 3 A (230V, AC15) |
