Phoenix RIF-0-RPT-24DC/21AU-Relay Module 2903368, a prefabricated relay module with in-line connection, including: a relay base with a pop-up device and a multi-layer gold-plated contact relay. Contact switching type: 1 changeover contact. Input voltage: 24V DC
Product Type
Relay Module
Product Series
RIFLINE complete
Application
General
Mode of operation
100% operating factor
mechanical life
about 2x 107times
insulation characteristics
insulation
security isolation
Overvoltage Category
III
pollution level
2
Data Management Status
Last data maintenance date
20.03.2025
service life, electrical
See Graph
rated conditions
0.22W
test voltage (coil/contact)
4 kVrms(50Hz,1 min, coil/contact)
Rated insulation voltage
250V AC
Rated overvoltage
6 kV
coil side
Rated input voltage UN
24V DC
Input Voltage Range
19.2V DC ... 36V DC (20 °C)
to UNas reference
See Graph
drives and functions
monostable
drive (polarity)
polarization
UN
9 mA
Typical Response Time
5 ms
Typical Release Time
8 ms
coil voltage
24V DC
protection circuit
freewheeling diode
Operating voltage display
yellow LED
switching
Contact Type
1 changeover contact
Switch Contact Type
single contact
Contact Material
AgSnO, hard gold plating
maximum switching voltage
30V AC
36V DC
Minimum Switching Voltage
100 mV (10 mA)
limit continuous current
50 mA
Maximum impact current
50 mA
minimum switching current
1 mA (12 V)
Maximum power rating (resistive load)
1.2W (24V DC)
Use Class CB Scheme (IEC 60947-5-1)
AC15, 3 A/250V (N/O contact)
AC15, 1 A/250V (normally closed contact)
DC13, 1.5 A/24V (N/O contact)
DC13, 0.2 A/110V (N/O contact)
DC13, 0.1 A/220V (N/O contact)
switching: when the gold plating layer is destroyed
Considerations
If the gold plating is damaged, the following values are applicable.
Contact Material
AgSnO
maximum switching voltage
250V AC/DC
Minimum Switching Voltage
5V (at 100 mA)
limit continuous current
6 A
minimum switching current
10 mA (at 12V)
Maximum power rating (resistive load)
140W (24V DC)
20W (available for 48V DC)
18W (available for 60V DC)
23W (available for 110V DC)
40W (available for 220V DC)
1500 VA (available for 250V AC)
switch capacity
2 A (24V, DC13)
0.2 A (at 110V, DC13)
0.1 A (220V, DC13)
3 A (24V, AC15)
3 A (120V, AC15)
3 A (230V, AC15)
Connection Mode
in-line connection
stripping length
8mm
Rigid conductor cross section
0.14 mm² ... 1.5 mm²
Flexible Wire Cross Section
0.14 mm² ... 1.5 mm²
0.14 mm² ... 1.5 mm² (cold press head with plastic sleeve)
