Phoenix RIF-1-RPT-LDP-24DC/1IC-Relay Module 2909884, a prefabricated relay module with a plug-in interface, including: relay base, power contact relay, plug-in display/interference suppression module and bracket. Contact type: 1 normally open contact, the maximum impulse current peak can reach 130 A,80 A (20 ms) output voltage 24V DC
Product Type
Relay Module
Product Series
RIFLINE complete
Application
Large impact current
Mode of operation
100% operating factor
mechanical life
3x 107Switch Times
Insulation Characteristics: Standards/Regulations
insulation
safety isolation, reinforced insulation
Overvoltage Category
III
pollution level
2
Data Management Status
Last data maintenance date
20.03.2025
rated conditions
0.43W
test voltage (coil/contact)
4 kV AC (50Hz,1 min, coil/contact)
Standards/Regulations
Rated insulation voltage
250V AC
Rated overvoltage
6 kV
coil side
Rated input voltage UN
24V DC
Input Voltage Range
19.2V DC ... 33.6V DC (20 °C)
to UNas reference
See Graph
drives and functions
monostable
drive (polarity)
polarization
UN
18 mA
Typical Response Time
8 ms
Typical release time
10 ms
coil voltage
24V DC
protection circuit
backup diode; freewheeling diode
Operating voltage display
yellow LED
switching
Contact Type
1 N/O contact
Switch Contact Type
Single contact
Contact Material
AgSnO
maximum switching voltage
250V AC/DC (When the voltage between the same terminals of two adjacent modules is greater than 250V(L1, L2, L3), a spacer PLC-ATP must be used. FBST 8-PLC... or... FBST 500... for equipotential bridging)
Minimum Switching Voltage
12V (100 mA)
limit continuous current
6 A
10 A (This value is allowed if terminals 11 and 21, and terminals 14 and 24 are bridged.)
Maximum impact current
80 A (20 ms)
130 A (peak, capacitive load, 230V AC, 24 μF)
minimum switching current
100 mA (12V DC)
Maximum power rating (resistive load)
264W (24V DC, pay attention to contact de-capacitance)
58W (available for 48V DC)
48W (available for 60V DC)
50W (available for 110V DC)
80W (available for 220V DC)
2750 VA (at 250V AC, pay attention to contact drop)
Minimum on-off capacity
1200 mW
Use Class CB Scheme (IEC 60947-5-1)
AC15, 6 A/250V (N/O contact)
DC13, 2 A/24V (N/O contact)
Connection Mode
in-line connection
stripping length
8mm
Rigid conductor cross section
0.14 mm² ... 1.5 mm²
Flexible Wire Cross Section
0.14 mm² ... 1.5 mm²
0.14 mm² ... 1.5 mm² (cold press head with plastic sleeve)
0.14 mm² ... 1 mm² (sleeve with plastic insulating sleeve, two wires on the two-position terminal)
