Phoenix RIF-1-RPT-LDP-24DC/1X21MS-Relay Module 2905289, a prefabricated relay module with in-line connection, including: relay base, relay fixing bracket, and power contact relay with test button, built-in status LED and freewheeling diode. Contact switching type: 1 changeover contact. Input voltage: 24V DC
Product Type
Relay Module
product series
RIFLINE complete
Application
General
Handheld Switch
Mode of operation
100% operating factor
mechanical life
approx. 5 x 106times
insulation characteristics
insulation
input and output
changeover contacts
Overvoltage Category
III
pollution level
2
Data Management Status
Last data maintenance date
20.03.2025
service life, electrical
See Graph
rated conditions
0.43W
test voltage (coil/contact)
4 kVrms(50Hz,1 min, coil/contact)
Rated insulation voltage
250V AC
Rated overvoltage
6 kV (input/output)
4 kV (between changeover contacts)
coil side
Rated input voltage UN
24V DC
Input Voltage Range
19.2V DC ... 30V DC (20 °C)
to UNas reference
See Graph
drives and functions
monostable
drive (polarity)
polarization
UN
18 mA
Typical Response Time
9 ms
Typical Release Time
10 ms
coil voltage
24V DC
protection circuit
freewheeling diode
Operating voltage display
yellow LED
switching
Contact Type
1 changeover contact
Switch Contact Type
Single contact
Contact Material
AgNi
maximum switching voltage
250V AC/DC
Minimum Switching Voltage
12V (10 mA)
limit continuous current
11 A (see graph)
Maximum impact current
24 A (20 ms, normally open contact)
minimum switching current
10 mA (12 V)
Maximum power rating (resistive load)
264W (24V DC)
62W (48V DC)
48W (60V DC)
52W (110V DC)
66W (220V DC)
2500 VA (250V AC)
Minimum on-off capacity
120 mW
Use Class CB Scheme (IEC 60947-5-1)
AC15, 3 A/250V (N/O contact)
DC13, 2 A/24V (N/O contact)
Connection Mode
in-line connection
stripping length
8mm
Rigid conductor cross section
0.14 mm² ... 1.5 mm²
Flexible Wire Cross Section
0.14 mm² ... 1.5 mm²
0.14 mm² ... 1.5 mm² (cold press head with plastic sleeve)
0.14 mm² ... 1 mm² (sleeve with plastic insulating sleeve, two wires on the two-position terminal)
