Phoenix PWT 100-800AC-FM-1/2 class lightning protection/surge protector 2800531, lightning protection/surge protector, meets the requirements of type 1/2/class I/II, used for 3-phase power supply Network, PE and N combination installed in one wire (L1,L2,L3,PEN).
Product Type
combination surge protector
product series
POWERTRAB
IEC Category
I / II
T1 / T2
EN Type
T1 / T2
IEC power supply system
TN-C
IT
type
Installation Module
Bits
3
Surge protection fault alarm
visual status indication window and remote alarm contact
insulation characteristics
Overvoltage Category
8 kV: IV (600 V), III (1000 V)
pollution level
3
Rated frequency fN
50Hz (60 Hz)
Rated voltage UN
690V AC
indicator/remote signaling
Connection Name
Remote alarm contact
switching function
2 N/C contacts, 1 position
Nominal operating voltage
30V AC
30V DC
Operating current
1.5 A AC
1.5 A DC
Power: Status Indicator/Remote
working voltage
19.2V AC/DC ... 30V AC/DC
working current
7 mA AC/DC ... 13 mA AC/DC
Rated current
10 mA AC/DC
1 A (e.g. T to IEC 127-2/III)
Anti-interference ability according to IEC 61000-4-5 (core to core)
1 kV
Anti-interference ability according to IEC 61000-4-5 (core to ground)
6 kV
dual wiring position
Connection Mode
screw connection
thread
M6
Tightening torque
8.5 Nm
stripping length
24mm
Flexible Wire Cross Section
16 mm² ... 50 mm²
Rigid conductor cross section
16 mm² ... 50 mm²
Attachable Guide Cross Section AWG
6 ... 1/0
PE line connection
Connection Mode
ring cable pin
Tightening torque
20 Nm
Flexible Wire Cross Section
16 mm² ... 95 mm²
Rigid conductor cross section
16 mm² ... 95 mm²
Attachable Guide Cross Section AWG
6 ... 3/0
Remote alarm contact
thread
M3
Tightening torque
0.55 Nm
stripping length
7mm
Flexible Wire Cross Section
0.2 mm² ... 2.5 mm²
Rigid conductor cross section
0.2 mm² ... 2.5 mm²
Attachable Guide Cross Section AWG
24 ... 12
Dimensional drawing
width
176mm
height
191mm
depth
280mm
Horizontal stitch pitch
10 Division
color
silver
flame retardant rating, according to UL 94
V-2
material
600
250
insulation material
PA/PC
Material Group
I (PA 6.6/PC)
IIIa (PA 4.6)
Shell Material
die-cast aluminum, salt water resistant
Shell surface material
aluminum die casting
Mechanical parameters
Open Side Panel
No
protection channel
L-PE
movement direction
3L-PEN
Rated voltage UN
690V AC
554/960V AC (TN-C)
690V AC (IT)
Rated frequency fN
50Hz (60 Hz)
Maximum continuous operating voltage UC(L-PE)
800V AC
Rated load current IL
150 A (50 mm² serial straight-through)
Residual Flow IPE
≤ 20 µA
2800531
넳넲
Phoenix PWT 100-800AC-FM-1/2 class lightning protection/surge protector 2800531
